Wednesday, September 2, 2015

About Car Service Long Island Airport

By Daphne Bowen


It is important to ensure that your car remains in a good state to avoid unnecessary expenses towards repairs. One of the parts which have to be serviced often times is the brake system. They are prone to dust accumulation. Moisture, heat and grime are likely to build up therein which ends up scorching the wheels. The dust clings onto the wheels via static electricity. Cleaning with a piece of cloth dipped in cold water is a very effective measure to get rid of the dirt in car service Long Island airport.

The pressure system of the car has to be checked on a regular basis. The recommended frequency is on a weekly basis. Besides making handling of the vehicle difficult, much fuel will be used if the pressure system is not okay. The process is very easy and no one can say that they are not in a position to do it in city Long Island, NY.

The depth of the tyre treads has also to be taken into account. For those who are involved in motor racing, sleek tyres are a must. However, for normal driving purposes the tyres have to be rugged. Some of tyre manufacturers make them with bars to indicate the level of wear and tear. The costs incurred in replacing just four tyres cannot be compared to the losses incurred in the event that an accident occurs.

Belts have to be considered in the servicing process too. The anterior part of an engine has several belts produced form rubber. This is a material prone to wear and tear especially if the conditions are not favorable. For every 25,000 miles covered, the accessory and timing drive belt need review and they should be replaced if a mileage more than 50,000 is covered.

It is vital to check the oil levels at a regular basis. This must be done on a regular basis. Anyone can check this. It must be done after the engine has cooled off. The dipstick should be taken out, cleaned and then replaced for accurate readings. The normal level should be between the low and high marking. If it is below the low marking, there is need to top it up.

The coolant level is another of the aspects to be checked too. The engine cannot operate without this device. Also, the readings need to be taken after the engine has cooled. The process is similar to that of checking for the oil level. The safe reading should be between the high and low marking.

A blinker will flash faster than that on the other side if one bulb is not working. This will mean that the defective bulb has to be changed. Dealers in auto parts can advise you on which one to get but you will need your vehicle manual for directions on how to go about doing the changes.

When replacing the bulbs, the glass of headlights should not be touched using bare hands. Many of these bulbs are filled with halogen and the grime left behind makes the glass susceptible to cracking in Long Island city, NY.




About the Author:



Related Posts Plugin for WordPress, Blogger...